Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: 1 [2]   Go Down

Author Topic: TVR1BB Engine build  (Read 8357 times)

xrad

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 602
  • Keeper of the Sun Dried Tomato
  • Location: Ohio USA
Re: TVR1BB Engine build
« Reply #25 on: April 18, 2018, 09:55:19 pm »
I used locktite blue bottle on linkage associated screws. Rest are just snugged tight. And also never got email replies to any questions.
Logged

ooyah/2

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 767
  • Location: Glasgow
Re: TVR1BB Engine build
« Reply #26 on: April 19, 2018, 06:00:28 am »
Quote from: xrad on April 18, 2018, 09:55:19 pm
{. And also never got email replies to any questions.}


xrad,
What were your questions as they are not listed in this  thread.?


George.
Logged

KNO3

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,531
  • Location: Bucharest
Re: TVR1BB Engine build
« Reply #27 on: November 04, 2018, 11:07:27 am »
Quote from: Captain fizz on February 17, 2018, 01:13:32 pm
Does anybody have experience of suggested weight/size for a flywheel?

My Tvr1a engine runs quite well without a flywheel. However, I had the marine flywheel offered as option by Graham, but since it looked so plain, I had it machined with a recessed face and a groove for a belt.
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Page created in 0.09 seconds with 24 queries.