Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: pic ESC for servo motors  (Read 4477 times)

Dainesh

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 67
  • Model Boat Mayhem is Great!
  • Location: United Kingdom
pic ESC for servo motors
« on: August 09, 2021, 10:01:07 am »

Hi Gewts,


I'm in a smaller project.
I have a 1/350 Trumpeter Viribus Unitis, and I was searching for small motors for it, until I saw the motors in the 9g micro servos.
I thought that I can use two servo motors to drive the two shafts from four.


I put the motors in with the controlling circuit and it was OK.


Now I would like to cotrol the both servo motors from the same signal, plus mix the left/right signal in it.
Logged

Dainesh

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 67
  • Model Boat Mayhem is Great!
  • Location: United Kingdom
Re: pic ESC for servo motors
« Reply #1 on: August 09, 2021, 10:06:33 am »

Here is the photo  ok2
Logged

xanthar

  • Shipmate
  • *
  • Offline Offline
  • Posts: 9
  • Model Boat Mayhem is Great!
  • Location: US
Re: pic ESC for servo motors
« Reply #2 on: January 12, 2023, 09:20:35 pm »

I'm curious how this worked out?
I'm guessing that these are continuous rotation servos?
Do they rotate fast enough to drive a small prop well ?
Logged

roycv

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 3,492
  • Location: S.W. Herts
Re: pic ESC for servo motors
« Reply #3 on: January 13, 2023, 04:09:52 am »

Hi when using standard servos as drive units it is usual to disconect the motor from the gearbox and drive a prop direct.  You are on new ground with this size servo.
Interested to know the outcome.
Regards
Roy
Logged
Pages: [1]   Go Up
 

Page created in 0.096 seconds with 23 queries.